Installing the Parking Brake (continued)
Chassis: Service and Repairs
g241042
1.
Brake hub
2.
Band lining
3.
Brake band
4. Install the brake band and shims (if any) with the 2 bolts, 4 flat washers,
and 2 locknuts.
Note: On GreensPro 1260 machines, use shims behind the brake hub to
center the hub in the brake band if necessary.
5. Tighten the socket-head screw that secures the brake hub to the drive roller
shaft.
6. Install the brake rod (item 22) to the brake pivot arm with the hairpin cotter.
7. Pass the brake rod through the brake band and install the spacer, flat washer,
and locknut on the end of the brake rod.
8. Connect the brake return spring to the chassis.
9. Adjust the parking brake; refer to the GreensPro Operator's Manual.
Figure 75
4.
Shim
5.
Chassis
Page 7–32
GreensPro
™
1240/1260
14211SL Rev A