Toro GreensPro 1240 Service Manual page 91

Removing the Transmission (continued)
GreensPro ™ 1240/1260
14211SL Rev A
4. Read and adhere to the
Hydraulic System Components (page
5. Clean the hydraulic hose ends and fittings being disconnected to prevent
hydraulic system contamination.
6. Drain the hydraulic fluid from the hydraulic tank into a suitable container.
7. For assembly purposes, label all the hoses and fittings. Remove the hoses
from the fittings on the transmission assembly. Drain the hoses into a
suitable container.
8. Install clean caps and plugs on the disconnected hoses and fittings to prevent
hydraulic system contamination.
9. On machines with serial number above 315000000, disconnect the wire
harness connector from the neutral switch.
10. Remove the hex nut and lock washer that secure the damper (item 3 in
Figure 32) to the damper plate, and disconnect the damper from the plate.
11. Remove the bolts, flat washers, spacers, and locknuts that secure the damper
plate and linkage rod to the transmission control arm (item 5 in
12. Remove the bolts, flat washers, locknuts, and spacers that secure the fan
and transmission drive collar to the drive coupling
g241038
1. Drive coupling
2. Bolt (2 each)
13. Remove the hex nut, spacer, and compression spring from the tension rod
(Figure 34).
General Precautions for Removing and Installing the
5–35).
Figure 33
3. Flat washer (4 each)
4. Spacer (2 each)
Page 5–45
Figure
(Figure 33).
5. Locknut (2 each)
Hydraulic System: Service and Repairs
32).