Toro GreensPro 1240 Service Manual page 80

Adjusting Procedure for GreensPro 1260 (continued)
Hydraulic System: Adjustments
g271960
1. RTN adjustment screw
2. Control arm assembly
B. Rotate the control arm assembly in the opposite direction of the drive
roller rotation in small increments.
C. Tighten the RTN adjustment screw to 24 to 30 N·m (18 to 22 ft-lb).
D. Start the engine, set the throttle to full engine speed and check for drive
roller rotation. repeat adjustment if necessary.
E. When the drive roller does not rotate, shut off the engine and install the
traction cable to the pedal rod pivot.
8. Start the engine and set the throttle to full engine speed.
9. Place a straightedge across the front of both motion control pedals to align
the pedals with each other.
10. If the drive roller rotates, loosen the jam nuts and adjust the traction cable so
the drive roller does not move when the motion control pedals are aligned
with each other.
11. Shut off the engine and install the transmission cover; refer to
Transmission Cover (page
12. The motion control pedals should contact the pedal stop bolts (item 4 in
Figure 28) just before the control arm assembly reaches the end of its rotation
(in both directions). Adjust the pedal stop bolts as necessary.
Figure 29
GreensPro 1260
3. To stop drive roller rotation to the left
4. To stop drive roller rotation to the right
7–59).
Page 5–34
Installing the
GreensPro ™ 1240/1260
14211SL Rev A