Toro GreensPro 1240 Service Manual page 59

Installing the Hydraulic Hoses and Tubes (continued)
GreensPro ™ 1240/1260
14211SL Rev A
A. Use a wrench to tighten the swivel nut onto the fitting until you feel light
resistance with the wrench; approximately 3.39 N∙m (30 in-lb).
B. Put a mark on the swivel nut and body of the fitting. Hold the hose/tube in
alignment with a wrench to prevent the hose/tube from turning
g221222
1. Mark nut and fitting body
2. Final position
Note: The markings on the nut and body of the fitting show that the
connection is correctly tightened.
C. Use a second wrench to tighten the nut to the correct Flats From Wrench
Resistance (FFWR).
Figure 15
3. Initial position
4. Extend line
Page 5–13
(Figure
Hydraulic System: General Information
15).