Toro GreensPro 1240 Service Manual page 77

Adjusting Procedure for GreensPro 1240 (continued)
GreensPro ™ 1240/1260
14211SL Rev A
g271843
1. RTN adjustment screw
2. Control arm assembly
B. Rotate the control arm assembly in the opposite direction of the drive
roller rotation in small increments.
C. Tighten the RTN adjustment screw to 24 to 30 N·m (18 to 22 ft-lb).
D. Start the engine, set the throttle to full engine speed and check for drive
roller rotation. repeat adjustment if necessary.
E. When the drive roller does not rotate, shut off the engine and attach the
linkage rod to the transmission control arm.
9. Start the engine and set the throttle to full engine speed.
10. Place a straightedge across the front of both motion control pedals to align
the pedals with each other
Figure 26
GreensPro 1240
3. To stop drive roller rotation to the left
4. To stop drive roller rotation to the right
(Figure 27).
Page 5–31 Hydraulic System: Adjustments