Hydraulic Pump (Greenspro 1260) - Toro GreensPro 1240 Service Manual

Hydraulic Pump (GreensPro 1260)

Removing the Hydraulic Pump
GreensPro ™ 1240/1260
14211SL Rev A
g272542
1. Hydraulic pump
2. Pump drive collar
3. Set screw (2 each)
4. Lock nut (2 each)
Refer to Figure 37 for this procedure.
Before opening the hydraulic system, shut off the engine and press
the motion control pedals to release the pressure in the system and
avoid injury from the pressurized hydraulic fluid.
Use a suitable lifting device to safely raise and support the machine
to access the components under the chassis.
1. Park the machine on a clean, shut off the engine and engage the parking
brake.
2. Remove the transmission cover from the machine; refer to
Cover (page 7–58).
3. Read and adhere to the
Hydraulic System Components (page
4. Clean the hydraulic hose ends and fittings being disconnected to prevent
hydraulic system contamination.
5. Drain the hydraulic fluid from the hydraulic tank into a suitable container.
Figure 37
5. Plain washer (4 each)
6. Square key
7. Cap screw (2 each)
CAUTION
CAUTION
General Precautions for Removing and Installing the
5–35).
Page 5–51
Transmission
Hydraulic System: Service and Repairs