Toro GreensPro 1240 Service Manual page 146

Removing the Drive Roller (GreensPro 1240)
Chassis: Service and Repairs
Refer to Figure 67 for this procedure.
Use a suitable lifting device to safely raise and support the machine
to get access to the components under the chassis.
1. Remove the transmission cover from the machine; refer to
Transmission Cover (page
2. Remove the hex nut, spacer, and compression spring (item 3 in
from the idler adjustment rod.
g241029
1. Hex nut
2. Spacer
3. Compression spring
4. Idler adjustment rod
5. Bolt
3. Remove the bolt, flat washers, locknut, pivot bushing, and spacer, and
remove the idler arm assembly from the machine.
4. Remove the drive roller sprocket from the taper lock bushing:
A. Remove the 2 set screws that secure the sprocket to the taper lock
bushing.
B. Oil the thread and the end of 1 of the set screws and insert the screw
in removal hole
the bushing side.
CAUTION
7–59).
Figure 68
6. Flat washer (2 each)
7. Locknut
8. Pivot bushing
9. Spacer
10. Idler arm assembly
(Figure 69). The bushing removal hole is threaded on
Page 7–20
Removing the
Figure 68)
GreensPro ™ 1240/1260
14211SL Rev A