Process And System Messages, Error Handling; Central Interface Module (Cim); Led Operating Display For Cim - Siemens SIPLUS HCS Series Operating Instructions Manual

Process and system messages, error handling

11.1

Central Interface Module (CIM)

11.1.1

LED operating display for CIM

The device has 3 LEDs on the front: The LEDs provide information about the operating state
of the device or system.
Meaning of LEDs
READY
green
Note
The LEDs of the CIM4210C PROFINET behave like those of the CIM4210.
SIPLUS HCS4200 PROFINET/PROFIBUS DP
Operating Instructions, 07/2019, A5E35066204A/006
HEATING ON ERROR
yellow red
Power OFF, device switched off
Initialization: The LED flashes until the HCS is detected and
accepted as a bus node by the higher-level control system.
Note
If a defective configuration is loaded in the case of reconfigura-
tion, this culminates in the following error display:
green = on
•
red = on
•
Device started up and ready
Heating "ON"
A general error has occurred:
Fieldbus communication error
Error in HCS communication
11
179