Siemens SIPLUS HCS Series Operating Instructions Manual page 56

Installation/mounting
5.2 Mounting the rack
Installing a rack
Install the rack in the following sequence:
Figure 5-1
Steps
1
2
3
4
54
Installing a rack
Drill the threads for the M6 fixing screws in the mounting plate.
The positions of the pre-fabricated mounting holes on the rack are shown in the drill hole tem-
plate (see figure below).
Screw the fixing screws into the mounting plate but do not tighten
Position the rack in the control cabinet
Screw the rack firmly into place
②
③
SIPLUS HCS4200 PROFINET/PROFIBUS DP
Operating Instructions, 07/2019, A5E35066204A/006
①