Table of Contents
Advertisement
Background transition
Selecting a bus
Select sources to be used for background transitions.
1
Press the crosspoint buttons.
f Depending on the operating status, the buttons pressed will light in one of three color patterns.
Type
High tally
Low tally
Preset tally
* Indicates the default colors. To change the colors, select the <PANEL> button on the top menu → [BUTTON COLOR] → [Settings] tab → [Select Button]
column.
f The color when lit for the buttons not selected can also be set by source or by block. (page 129)
Selecting a bus using the SHIFT function
The SHIFT function is to switch pages of the crosspoint buttons with the <2nd PAGE>/<3rd PAGE> button.
There are two ways to perform the SHIFT function.
All SHIFT
Single SHIFT
The <2nd PAGE>/<3rd PAGE> buttons are available in two modes. The setting can be changed using the menu. (page 118)
[Normal]
[Page Lock]
Selecting the bus mode
Set the bus operating mode.
page 118
(
1
Select the <OPR> button → [OTHER SETTINGS] → [Bus Mode] tab.
2
Set an item in [Bus Mode] in the [Bus Mode] column.
[A/B]
[PGM-A/PST-B]
[PGM-B/PST-A]
Transition operations
Operate transitions using the transition area on the Control Panel.
1
Select the transition type.
f Use the transition type selection buttons. (page 26)
2
Execute the transition using the fader lever or the transition execution button.
Manual transition
Auto transition
Cut transition
f The lighting of the bus name display panel to the right of the PGM/A bus crosspoint buttons and PST/B bus crosspoint buttons, whether High tally
color or Low tally color, indicates the output status of the buses.
Lighting color
High tally
Low tally
Off
r Setting the transition time
1
Select the <ME1>/<ME2> button → [BKGD] → [Transition] tab.
2
Select [AUTO Time] in the R menu, and set [AUTO Time] in the encoder menu.
Chapter 5 Basic Operations — Background transition
Color when lit*
[Red]
[Yellow]
[Green]
Use the <2nd PAGE>/<3rd PAGE> button to switch all pages of buses included in the corresponding ME at once.
(page 25)
Assign the <2nd PAGE>/<3rd PAGE> button to the crosspoint buttons to switch pages. (page 115)
Using the assigned button, only the pages of individual bas can be switched.
The buttons are turned on only while they are pressed.
The buttons are turned on and off each time they are pressed.
)
When the fader lever is at side A, the signals selected on the A bus are used as the source of the PGM bus.
When the fader lever is at side B, the signals selected on the B bus are used as the source of the PGM bus.
Using a flip-flop system, the signals selected on the A bus are always used as the source of the PGM bus, and the
signals selected on the B bus are always used as the source of the PST bus.
Using a flip-flop system, the signals selected on the B bus are always used as the source of the PGM bus, and the
signals selected on the A bus are always used as the source of the PST bus.
Move the fader lever to execute the transition.
Press the <AUTO> button to execute the transition automatically.
Press the <CUT> button to execute the transition instantaneously.
Lights when the relevant bus is included in the on-air output.
Lights when the relevant bus is not included in the on-air output but included in the program output.
Lights when the relevant bus is included in neither the on-air output nor the program output.
Lights when the selected source is included in the on-air output.
Lights when the selected source is not included in the on-air output but
included in the program output.
Lights when the selected source is included in neither the on-air output
nor the program output.
Description
– 51 –
Description
Advertisement
Table of Contents
