Table of Contents
Advertisement
f Set the transition time.
NOTE
@
t The units used for time display of the unit can be set to either in seconds/frame or in frames. (page 118)
r Setting the start and end points of a transition
1
Select the <ME1>/<ME2> button → [BKGD] → [Transition] tab.
2
Select [Margin Adjust] in the R menu, and set [Start Point] and [End Point] in the encoder menu.
[Start Point]
[End Point]
f While the <PATT LIMIT> button is lighting up, the settings of [Start Point] and [End Point] are disabled.
r <NAM/CMIX> button setting
Set the behavior of background transition when the <MIX> button is on.
1
Select the <ME1>/<ME2> button → [BKGD] → [Transition] tab.
2
Select the items in [NAM/CMIX] and [Type] in the [NAM/CMIX] column.
f The settings for [NAM/CMIX] are linked to the lighting status of the <NAM/CMIX> button.
[NAM/CMIX] items
[OFF]
[ON]
r Transition curve settings
1
Select the <ME1>/<ME2> button → [BKGD] → [Transition] tab.
2
Select the items in [MIX] and [WIPE] in the [Trans Curve] column.
f The transition curve can be set individually for each of MIX and WIPE according to the selection state of the transition type.
[Linear]
[S Soft]
[S Mid]
[S Hard]
Chapter 5 Basic Operations — Background transition
Sets the start point for the background transition.
The background transition will start after the start point of the manual transition or the auto transition when a value
larger than 0 is set for [Start Point]. At this time, the lamp for start point of the fader lever will blink in the transition status
display.
Sets the end point for background transition.
The background transition will complete before the end point of the manual transition or the auto transition when a value
larger than 0 is set for [End Point]. At this time, the lamp for end point of the fader lever will blink in the transition status
display.
[Type] items
―
[NAM]
[CMIX]
Straight line
A shallow S curve
An intermediate S curve
A deep S curve
Images switch by overlapping.
During the transition, the output total of the A bus and B bus is kept at
100%.
Switches the images in the A bus/B bus with non-additive mixing.
It will be high luminance with the A bus at 100% and the B bus at 100%
when the fader lever is positioned midway.
The images are mid way between the A bus and B bus images,
becoming a MIX composition that is the color set in [CMIX Matte] in the
R menu. (Color mix composition)
– 52 –
Image operations
Advertisement
Table of Contents
