Panasonic Live Production Suite Series Operating Manual page 57

- SQ: 42, 43, 44, 45
1
Select the <ME1>/<ME2> button → [BKGD] → [Modify] tab.
2
Select [H Modulation] and [V Modulation] in the R menu, and set [Amplitude], [Frequency], and [Speed] in the encoder menu.
[Amplitude]
[Frequency]
[Speed]
3
Select the items in [H Pattern] and [V Pattern] in the [Modulation] column.
[Sine]
[Delta]
Setting the transition MID Position
Adjusts the position and size of the pattern waveform when the transition amount is in the range of 40% to 60% (mid position).
f Enabled when the following pattern waveforms are selected.
- SQ: 51, 52, 53, 54
1
Select the <ME1>/<ME2> button → [BKGD] → [Position] tab.
2
Select [MID Position] in the R menu, and display the encoder menu.
3
Set [X] and [Y] in the encoder menu.
Sets the position of the pattern waveform.
f SQ: 51 will place two sub-screens symmetrical to the Y axis.
f SQ: 52 will place two sub-screens symmetrical to the X axis.
f SQ: 53 will place two sub-screens symmetrical to the center point.
4
Set [Size] in the encoder menu.
Sets the size of the pattern waveform.
Setting the transition start position
1
Select the <ME1>/<ME2> button → [BKGD] → [Position] tab.
2
Select [Pos/Size] in the R menu, and set [X], [Y], and [Size] in the encoder menu.
Setting the transition mid position
1
Select the <ME1>/<ME2> button → [BKGD] → [Position] tab.
2
Select [MID Position] in the R menu, and set [X], [Y], and [Size] in the encoder menu.
3
Select the [Transition] tab.
4
Select [Margin Adjust] in the R menu, and set [Mid Margin] in the encoder menu.
f Set the mid area.
Setting spin effects
1
Select the <ME1>/<ME2> button → [BKGD] → [Position] tab.
2
Select the items in the [Spin Mode] column.
[Off]
[Trans Spin]
[Auto Spin]*
[Manual Spin]*
* It may become discontinuous at the edge of transition in the [Auto Spin] or [Manual Spin] modes.
3
Select [Spin] in the R menu, and set [X-Spin], [Y-Spin], and [Z-Spin] in the encoder menu.
f This sets the amount of rotation of the spin effect during background transition.
@ NOTE
t Adjust to an angle so that you cannot see side surfaces other than the added side surface.
Chapter 5 Basic Operations — Wipe
Sets the amplitude of the wave.
Sets the frequency of the wave.
Sets the speed of the wave movement.
Selects sine waves.
Selects delta wave.
Does not spin regardless of setting value of [X-Spin], [Y-Spin], and [Z-Spin].
The spin will be at the specified spin amount between the mid position and the end point.
The behavior will be the same as [Manual Spin], irrespective of the [Spin] setting in the R menu.
Tilts in specified amount of spin regardless of the transition.
– 57 –