Mitsubishi Electric MELIPC MI5000 Series User Manual page 199

■Slave station parameter processing
From the station list, select the module  [CC IE Field configuration]  [Online]  [Slave station parameter processing]
Set or read the slave station parameters. This can only be executed if the slave station supports parameter processing.
Settings ranges differ depending on the covered module. For details, refer to the manual for the used slave station.
■Slave station command execution
From the station list, select the module  [CC IE Field configuration]  [Online]  [Slave station command execution]
Execute slave station commands. This can only be executed if the slave station supports command execution. Settings
ranges differ depending on the covered module. For details, refer to the manual for the used slave station.
■Link equal assignment and same point assignment for link numbers
Equal assignment and same point assignment are set as follows.
Item Description
Equal assignment Specify the header station and end station, and assign the link path total point
numbers equally.
• Header station: Set the station number of the header station for equal
assignment.
• End station: Set the station number of the end station for equal assignment.
• Header number: Set the number of the link devices for equal assignment.
• Assignment total point numbers: Set the total point number of the link
devices for equal assignment.
Same point The same point number is assigned for numbers of link devices.
assignment
Setting range
• Header station: 0 to end station number
• End station: Header station to end station number
• Header number: Same as "RX/RY settings" and
"RWw/RWr settings"
• Assignment total point numbers: Same as "RX/RY
settings" and "RWw/RWr settings"

18 APPRICATION PARAMETERS
18.2 Network Configuration Settings
18
197