Mitsubishi Electric MELIPC MI5000 Series User Manual page 6

[Startup and Maintenance Precautions]
WARNING
● Do not touch any terminal while power is on. Doing so will cause electric shock or malfunction.
● Correctly connect the battery connector. Do not charge, disassemble, heat, short-circuit, solder, or
throw the battery into the fire. Also, do not expose it to liquid or strong shock. Doing so will cause the
battery to produce heat, explode, ignite, or leak, resulting in injury and fire.
● Shut off the external power supply (all phases) used in the system before cleaning the module or
retightening the terminal screws, connector screws, or module fixing screws. Failure to do so may
result in electric shock.
● Tighten the terminal screws or connector screws within the specified torque range. Undertightening
can cause drop of the screw, short circuit, fire, or malfunction. Overtightening can damage the screw
and/or module, resulting in drop, short circuit, fire, or malfunction.
[Startup and Maintenance Precautions]
CAUTION
● Do not disassemble or modify the product. Doing so may cause failure, malfunction, injury, or a fire.
● Use any radio communication device such as a cellular phone or PHS (Personal Handy-phone
System) more than 25cm away in all directions from the product. Failure to do so may cause
malfunction.
● Shut off the external power supply (all phases) used in the system before mounting or removing the
product. Failure to do so may cause the product to fail or malfunction.
● Do not touch any part of your body or contact any object to the rotating fan. Doing so may result in
injury or failure of the fan module.
● After the first use of the product, do not connect/disconnect the power supply module or fan module
to/from the main module more than 50 times. Exceeding the limit may cause malfunction.
● After the first use of the product, do not insert/remove a CFast card to/from the product more than
10000 times. Exceeding the limit may cause malfunction.
● Place hands to hold a CFast card when removing it from the slot because the card may be jumped
out. If not placing hands, the card may fall, resulting in damage or failure.
● Do not drop or apply shock to the battery to be installed in the product. When removing the battery,
hold the connector part so that the battery cable is not damaged.
● Before handling the product, touch a conducting object such as a grounded metal to discharge the
static electricity from the human body. Failure to do so may cause the product to fail or malfunction.
● Do not remove the protective sheets attached to the plate of the base part and the center of the upper
section of the module case. The plate of the base part also acts as a heat sink and may be very hot
during operation. To prevent a burn, do not remove these sheets or touch them during operation or
immediately after the power supply is switched off.
● Usage under high temperature and humidity may cause the fan module to change colors, but this
does not affect performance.
● Do not turn OFF the power, reset this product, or remove the USB device during access of the USB
device. This may cause data corruption on the USB device or a malfunction of the USB device. Stop
access, and then remove the USB device.
4