Mitsubishi Electric MELIPC MI5000 Series User Manual page 225

Error code Error name
1848H Power supply temperature error
1849H MELIPC temperature error
184AH Number of CFast card writes
exceeded
184BH Power supply temperature sensor
fault
184CH USB port fault
184DH CFast card error
184EH CFast card error
184FH DisplayPort error
1850H Windows part stop
1851H CFast card error
1852H CFast card error
20E0H Invalid power supply module
2160H IP address overlap error
Description
Internal temperature abnormality has been
detected in the power supply module.
A MELIPC temperature error was detected.
The number of writes to the CFast card
exceeded 10,000. (Number of writes >
10,000)
A temperature sensor fault in the power
supply module has been detected.
An overcurrent to the USB port has been
detected.
An overcurrent to the CFast card has been
detected.
Insertion/removal of the CFast card has
been detected.
An overcurrent to the DisplayPort has been
detected.
A stop (no response) condition such as a
Windows blue screen is detected.
An error has been detected in the CFast
card.
An error has been detected in the CFast
card.
A power supply module that cannot be
recognized was detected.
An IP address overlap was detected.
Corrective action
Reset the system. If the same error is
displayed again, this may indicate a
hardware fault. Consult your local Mitsubishi
representative.
If this problem is not resolved, a hardware
error may result from a temperature error.
Take the following measures.
• Check the ambient temperature.
• Check that the vent of the MELIPC is not
blocked.
• Inspect and clean the fan module.
• Replace the fan module. If the same error
is displayed again, this may indicate a
hardware fault. Consult your local
Mitsubishi representative.
• Replace the fan module.
• Take measures to reduce the
temperature.
• If the same error is displayed again, this
may indicate a hardware fault. Consult
your local Mitsubishi representative.
Replace the CFast card.
Reset the system. If the same error is
displayed again, this may indicate a
hardware fault. Consult your local Mitsubishi
representative.
• Replace the USB.
• Reset the system. If the same error is
displayed again, this may indicate a
hardware fault. Consult your local
Mitsubishi representative.
• Replace the CFast card
• Reset the system. If the same error is
displayed again, this may indicate a
hardware fault. Consult your local
Mitsubishi representative.
Reset the system. If the same error is
displayed again, this may indicate a
hardware fault. Consult your local Mitsubishi
representative.
• Review the DisplayPort connection.
• Reset the system. If the same error is
displayed again, this may indicate a
hardware fault. Consult your local
Mitsubishi representative.
• Review the software applications on the
Windows part.
• Review the devices of the Windows part.
• Review the user programs of the
Windows part.
• Restart the Windows part.
• If the issue is still not resolved, replace
the MELIPC.
• Replace the CFast card.
• Take measures to reduce noise.
• Reset the system. If the same error is
displayed again, this may indicate a
hardware fault. Consult your local
Mitsubishi representative.
Replace the CFast card.
Mount only applicable power supply
modules.
Check the IP address of the Ethernet port
(CH1).
APPX
Appendix 2 List of Error Codes
A
223