Mitsubishi Electric MELIPC MI5000 Series User Manual page 283

No. Name
SW01C0 Each station CC-Link IE Field Network
to synchronous communication function
SW01C7 information
SW01C8 Each station synchronized/not
to synchronized operation status
SW01CF information
SW01E9 Synchronous communication cycle
overrun count
SW01EA Synchronous communication cycle
settings value
SW01EB
Description
Stores supported/not supported for each station CC-Link IE Field Network synchronous
communication function settings status.
• 0: Not supported
• 1: Supported
The numbers within the following illustration indicate the station numbers. (: fixed at 0)
b15
SW01C0 16 15 14 13 12
SW01C1 32 31 30 29 28
SW01C6 112 111 110 109 108
SW01C7 - - - - -
<Conditions>
• Enabled when 'baton pass status' of own station (SB0047) is OFF. When 'baton pass status of own
station' (SB0047) is ON (error), the data immediately before is retained.
• Only enabled for stations with normal 'each station baton pass status' (SW00A0 to SW00A7).
• The status is not stored for the station numbers after the maximum station number.
Stores each station CC-Link IE Field Network synchronous communication function operational
status.
• 0: Not synchronized
• 1: Synchronized
The numbers within the following illustration indicate the station numbers. (: fixed at 0)
b15
SW01C8 16 15 14 13 12
SW01C9 32 31 30 29 28
SW01CE 112 111 110 109 108
SW01CF - - - - -
<Conditions>
• Enabled when 'baton pass status' of own station (SB0047) is OFF. When 'baton pass status of own
station' (SB0047) is ON (error), the data immediately before is retained.
• Stations that have not run an inter-module synchronous interrupt program because the CPU
operating status is STOP or similar are also not synchronized (0).
• Only enabled for stations with normal 'each station baton pass status' (SW00A0 to SW00A7).
• The status is not stored for the station numbers after the maximum station number.
Shows the count for when link scan does not complete within the synchronous communication cycle.
Clear by turning the power supply OFF to ON, or clearing the reset state.
• 0: No cycle overrun event
• 1 to 65535: Accumulated number of cycle overrun events
Stores the synchronous communication cycle settings value. (Units: μs)
b0
~ 5 4 3 2 1
~ 21 20 19 18 17
~
~ 102 101 100 98 97
~ 117 116 115 114 113
b0
~ 5 4 3 2 1
~ 21 20 19 18 17
~
~ 102 101 100 98 97
~ 117 116 115 114 113
Appendix 8 List of Link Special Registers
A
APPX
281