Siemens MOBY FC 56 Technical Description page 121

Parameterization with GSD file
In addition to the PROFIBUS–related control parameters, the GSD file for the
ASM 452 also specifies several MOBY–related control parameters. The
MOBY–related parameters are set in "Objekteigenschaften" of the slave in HW
Config. The following table shows the settings which can be made.
Table A-3 Settings of the MOBY-related parameters
Parameter Name
MOBY mode
Baud rate f. SLG MOBY U 19.2 kbaud
Input parameters for ASM 452
Assignment takes place in UDT 10 (see chap. 3).
Table A-4 Input parameters for ASM 452
Address Name
+0.0 ASM_address
+2.0 ASM_channel
+8.0 MDS_IO_control
+9.0 ECC_mode
+9.2 priority_RW
+9.3 priority_RWD
+10.0 MOBY_mode
+11.0 scanning_time
+12.0 SLG_number
+14.0 distance_limiting
+15.0 multitag
+16.0 field_ON_control
+17.0 field_ON_time
Command table of ASM 452
The ASM 452 processes all the commands described in chapter 4.
FC 56
J31069-D0155-U001-A0-7618
Value
MOBY I, E, F normal addressing
MOBY I filehandler
MOBY U/D normal addressing
MOBY U filehandler
57.6 kbaud
Permissible Values
0, 4, 8, 12 ....
1
B#16#0, 1, 4, 5
TRUE, FALSE
TRUE, FALSE
TRUE, FALSE
B#16#1, 5, 6
B#16#00 ... FF
B#16#0001 ... FFFF
B#16#05, 0A, 0F, 14,
19, 1E, 23
B#16#1
B#16#0, 1, 2
B#16#00 ... FF
Short Description of the ASM Hardware
Remarks
(Default)
FC 46 or FC 56
FC 46 or FC 56 (multitag)
(Default)
Comments
Each ASM 452 occupies 4 bytes of I/O in
the I/O area of the controller
1 channel per ASM
Enable/disable presence check
TRUE is only permitted when
MOBY_mode is parameterized with 1.
(see chapter 3.1)
(see chapter 3.1)
MOBY I/U
A value other than 00 is only recom-
mended when MOBY_mode was para-
meterized appropriately (see chapter 3.1)
The test function is on for FFFF (see
chapter 3.1).
A-9