Huawei 2288H V5 User Manual page 272

2288H V5 Server
User Guide
Step 4 On the client, open the SSH tool and set related parameters, such as the IP address.
Step 5 Connect to the iBMC and enter the user name and password.
----End
Logging In over the Serial Port
Step 1 Set the serial port as the iBMC serial port.
You can set the serial port through the iBMC CLI or by using a jumper of the server.
l
l
Step 2 Use a serial cable to connect the terminal serial port and the server serial port.
Issue 04 (2018-09-04)
NOTE
l Local and LDAP users can both log in to the iBMC CLI over SSH.
l To log in to the iBMC, LDAP users do not need to enter information about the domain server, which
is automatically assigned by the system.
To set the serial port through the iBMC CLI, do as follows:
a. Log in to the iBMC CLI over SSH.
b. Run the following command to change the serial port direction:
ipmcset -d serialdir -v <option>
Parameter Description
<option> Serial port direction
To set the serial port by using a jumper, do as follows:
a. Power off the server and remove the power cables.
b. Place the jumper cap on COM_SW pins. For details about the jumper position, see
2.6 Mainboard
c. Connect the power cables and power on the server.
Copyright © Huawei Technologies Co., Ltd.
Components.
14 Common Operations
Value
The value options of this parameter and
the value meanings vary according to the
server model. You are advised to run the
ipmcget -d serialdir command to view
the value options.
For the 2288H V5 server, the options are
as follows:
– 0: switch from PANEL COM to SYS
COM
– 1: switch from PANEL COM to
iBMC COM
– 2: switch from SOL COM to SYS
COM
– 3: switch from SOL COM to iBMC
COM
To set the panel serial port as the iBMC
serial port, run the ipmcset -d serialdir -
v 1 command.
263