Connecting A Usb Device; Connecting A Serial Cable - Huawei 2288H V5 User Manual

2288H V5 Server
User Guide
Step 6 Check that the new cable is properly connected.
Power on the server. If the LOM indicator is green, the cable is properly connected.
Step 7 Bind the new optical cable.
Bind the new optical cable in the same way as existing optical cables. You can also remove all
cable ties and bind all of the optical cables again if necessary.
----End

4.5.6 Connecting a USB Device

Step 1 Wear an ESD wrist strap. For details, see
Step 2 Connect the USB device to a USB port on the server. See
Figure 4-21 Connecting a USB device
----End

4.5.7 Connecting a Serial Cable

The rear panel of the server provides one standard RJ45 serial port, which works as the
system serial port by default. You can set it as the iBMC serial port by using the iBMC CLI.
The serial port can be used as:
l
l
Issue 04 (2018-09-04)
System serial port to monitor the OS status
iBMC serial port for debugging and fault locating
Copyright © Huawei Technologies Co., Ltd.
12 Preventing Electrostatic
Figure
4 Setup
Discharge.
4-21.
88