Installing A Sas/Sata Drive - Huawei 2288H V5 User Manual

2288H V5 Server
User Guide
Step 7 If you do not install a new drive immediately, install a drive filler in the slot.
----End

5.3.2 Installing a SAS/SATA Drive

Step 1 Wear an ESD wrist strap. For details, see
Step 2 If the server is equipped with a front bezel, remove the bezel before installing a front drive.
For details, see
Step 3 If the drive is in the built-in drive module, perform the following operations:
If the chassis cover is away for too long while the server is powered on, some components
will become overheated. Install the chassis cover within 3 minutes.
1.
2.
Step 4 Remove the drive filler using the same method for removing a drive.
Issue 04 (2018-09-04)
NOTE
l You do not need to power off the server when installing a drive.
l After a failed drive is disconnected from the drive backplane, wait for 30 seconds before removing it
and inserting a new one. The alarm persists after a new drive is installed and will be cleared after the
RAID array is rebuilt. Do not frequently hot-swap a drive to prevent new alarms.
5.2.1 Removing the Front
NOTICE
Remove the chassis cover. For details, see
Open the handles of the built-in drive module. See
Figure 5-7 Opening the handles of the built-in drive module
Copyright © Huawei Technologies Co., Ltd.
12 Preventing Electrostatic
Bezel.
3.4 Removing the Chassis
Figure 5-7.
5 Optional Part Installation
Discharge.
Cover.
118