Pu Display Language Selection; Buzzer Control - Mitsubishi Electric 800 Series Instruction Manual

Reset limit function (P.E107)
• When P.E107 = "1" or Pr.75 = any of "100 to 103, 114 to 117, 1100 to 1103, or 1114 to 1117", if an electronic thermal O/L
relay or an overcurrent protective function (E.THM, E.THT, E.OC[]) is activated while one of them has been already
activated within 3 minutes, the inverter will not accept any reset command (RES signal, etc.) for about 3 minutes from the
second activation.
• The reset limit function is available with the FR-A860-01440 or higher.
NOTE
• Resetting the inverter power (turning OFF the control power) will clear the accumulated thermal value.
• When the retry function is set enabled (Pr.67 Number of retries at fault occurrence  "0"), the reset limit function is
disabled.
CAUTION
 Do not perform a reset while a start signal is being input. Doing so will cause a sudden start of the
motor, which is dangerous.
Parameters referred to ???????
Pr.67 Number of retries at fault occurrence
Pr.79 Operation mode selection
Pr.250 Stop selection page 607
Pr.551 PU mode operation command source selection
5.7.3

PU display language selection

The display language of the parameter unit (FR-PU07) can be selected.
Pr. Name
145 PU display language
E103 selection
5.7.4

Buzzer control

The PU (operation panel or parameter unit) key sound and buzzer can be turned ON/OFF.
Pr. Name
990
PU buzzer control
E104
NOTE
• When with buzzer is set to ON, a warning sound will be audible when a fault occurs.
page 327
page 291
page 301
Initial value
―
Initial value
1
(E) Environment setting parameters
Setting range
0 Japanese
1 English
2 German
3 French
4 Spanish
5 Italian
6 Swedish
7 Finnish
Setting range
0 Turns the key sound and buzzer OFF.
1 Turns the key sound and buzzer ON.
Description
Description
247
PARAMETERS
5
GROUP
E