NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
Steps
1. Using the alignment posts, place the speakers in the slots on the palm rest and keyboard assembly and snap the speakers
into place.
2. Route the speaker cable through the routing guides on the palm rest and keyboard assembly.
NOTE:
Push the rubber gourmets inside if it pops out while replacing the speakers.
3. Connect the speaker cable to the system board.
4. Slide the status-light board cable into the connector on the system board and close the latch to secure the cable.
Post-requisites
Steps
1. Replace the battery.
2. Replace the
hard
drive.
3. Replace the
I/O
board.
4. Replace the
base
cover.
5. Replace the
optical
drive.
44
Replacing the speakers
Replacing the speakers
computer. After working inside your computer, follow the instructions in
24
After working
www.dell.com/