Mitsubishi Electric MELSEC-Q Series User Manual page 147

3 SPECIFICATIONS
3 - 112
(c) The following lists the setting ranges.
• No link: Set 0 (default).
• Patten 1: Set 1.
• Patten 2: Set 2.
• Patten 3: Set 3.
(d) The program pattern and segment No. in execution can be monitored in
Execution pattern monitor (buffer memory address: 264, 520) and Segment
monitor (buffer memory address: 256, 512).
(e) When a program pattern of the link source is set, the program pattern will be
repeated endlessly.
(3) Program pattern iteration
(a) The number of execution times (cycles) of the program control is set.
(b) If the value 2 or more is set, the Q62HLC executes the program pattern
repeatedly.
When the program pattern is executed repeatedly, the set value of the
segment 1 starts from the set value at the pattern end after the second
execution or later.
Set value
Set value for the
(SV)
second execution
or later
(c) When the program pattern has been linked, all patterns are executed
repeatedly.
In this case, the number of execution times of the program pattern specified
in Execution pattern (buffer memory address: 272, 528) becomes valid.
(d) The pattern end output is performed only for the final execution.
(e) The current number of execution times of the program pattern can be
checked in Execution times monitor (buffer memory address: 258, 514).
(f) The setting range is 1 to 1000 (1 to 999 times, endless).
When 1000 is set, the program pattern will be repeated endlessly.
MELSEC-Q
Pattern end
Time
3 - 112