Mitsubishi Electric MELSEC-Q Series User Manual page 162

5 UTILITY PACKAGE (GX Configurator-TC)
Function
Monitor/test
5 - 3
•CH Alert 1 mode setting
•CH Alert set value 1
•CH Alert 2 mode setting
•CH Alert set value 2
•CH Alert 3 mode setting
•CH Alert 3 set value
•CH Alert 4 mode setting
•CH Alert 4 set value
•Alert dead band setting
•Alert delay count
•CH Loop disconnection detection judgment
time
•CH Loop disconnection detection dead
band
•CH Forward/reverse action setting
•CH Control mode
•CH Control mode monitor
•Approach range setting
•Approach soak time setting
•CH Stop mode setting
•PID continuation flag
•Auto tuning
• Setting/operation mode status
• Setting/operation mode command
•CH Set value (SV) setting
•CH Proportional band (P) setting
•CH Integral time (I)
•CH Derivative time (D)
•CH Control response parameter
•CH MAN output setting
•CH Program control run/reset
•CH Hold command
•CH Command advancing
•CH Execution times monitor
•CH Execution pattern monitor
•CH Segment monitor
•CH Segment remaining time
POINT
GX Configurator-TC does not support functions added to products with the serial
number (first five digits) of "13102" or later. Set those functions using sequence
programs or GX Works2 of version 1.73B or later. For the functions added to
products with the serial number (first five digits) of "13102" or later, refer to
Appendix 2 (2).
Description
•CH Zone PID monitor
•CH Wait status flag
•CH Hold status flag
•CH Advancing completion flag
•CH Pattern end output flag
•CH End status flag
•Setting change command
•CH Execution pattern
•CH Start mode
•CH Time scale
•CH Zone Upper limit
Proportional band (P) setting
Integral time (I)
Derivative time (D)
Control response parameter
•CH Program pattern
Final segment
Pattern link
Iteration
Output time of pattern end
Wait zone setting
Segment
Set value (SV) setting
Executing time
Zone PID data No.
•Cascade monitor
•Cascade bias
•Cascade gain
•Cascade ON/OFF
•CH Scaling value
•CH Scaling range upper limit value
•CH Scaling range lower limit value
•CH Scaling width upper limit value
•CH Scaling width lower limit value
MELSEC-Q
(From the previous page)
Reference
Section 5.6
5 - 3