Mitsubishi Electric MELSEC-Q Series User Manual page 88

3 SPECIFICATIONS
Setting mode
11)
8)
Normal control mode
9)
Setting mode
12)
Normal control mode
15)
3 - 53
(c) Between control modes (8) to 15) in the figure below)
The mode is switched by setting a value in Control mode (buffer memory
address: 50, 82) when Setting/operation mode status (Xn1) is set to on.
After the mode is switched, the new control mode is stored in Control mode
monitor (buffer memory address: 30)
Program control mode
Manual control mode 1
Manual control mode 2
14)
Program control mode
13)
Manual control mode 1
Manual control mode 2
*2: The control status at switching differs depending on the intelligent function
module switch setting (refer to (3) in this section).
(2) Control status
The Q62HLC has three control status: PID control, temperature judgment, and alert
judgment.
The control status of the Q62HLC is as listed below.
(a) Intelligent function module switch setting
Output setting at CPU stop error (refer to Section 4.5)
Intelligent function module switch setting
If a CPU stop error occurs at the setting of "CLEAR"
Other than above
(b) Unused channel setting
Unused channel setting
(buffer memory address 61, 93:)
(refer to Section 3.5.32)
Unused
Used
Value in Control mode (buffer memory address:
No.
10)
8)
9)
10)
11)
Value in Control mode (buffer memory address:
No.
12)
13)
14)
15)
MELSEC-Q
50, 82)
1
3
2 *2
0
50, 82)
2 *2
1
3
0
Control status
Temperature
PID control
judgment
— —
In accordance with control
status of other setting items
: Executed, —: Not executed
Control status
Temperature
PID control
judgment
— —
In accordance with control
status of other setting items
: Executed, —: Not executed
Alert
judgment
—
Alert
judgment
—
3 - 53