Mitsubishi Electric MELSEC-Q Series User Manual page 161

5 UTILITY PACKAGE (GX Configurator-TC)
Function
(1) Set the Q62HLC buffer memory performed the auto refresh in each channel
•Error Code
•CH
•CH
•CH
•CH
•CH
•CH
Auto refresh setting
•CH
•CH
•CH
•CH
•CH
time
(2) The values stored in the Q62HLC buffer memory where the auto refresh setting was set are
automatically read when the END instruction of the programmable controller CPU is executed.
Monitors and tests the buffer memory and I/O signals for the Q62HLC.
The auto tuning function can be used.
•Error code
•CH
•CH
•CH
•Cold junction temperature measured value
•CH
•CH
•CH
•CH
•CH
•CH
Monitor/test
•CH
•CH
•X00: Watchdog timer error flag
•X01: Setting/operation mode status
•X02: Error flag
•X03: Module ready flag
•X04:CH1 Auto tuning status
•X05:CH2 Auto tuning status
•X08: FeRAM write completion flag
•X09: Default value write completion flag
•X0A: FeRAM write failure flag
•X0B: Setting change completion flag
•X0C: CH1 Alert flag
5 - 2
Description
Measured value (PV)
Manipulated value (MV)
Set value monitor
Approach flag
Alert definition
Alert set value 1 to 4
Set value (SV) setting
Proportional band (P) setting
Integral time (I)
Derivative time (D)
Loop disconnection detection judgment
Measured value (PV)
Manipulated value (MV)
Set value monitor
Approach flag
Input range
Sensor compensation value setting
Primary delay digital filter setting
Unused channel setting
PID constant read command from
FeRAM
PID constant read completion flag from
FeRAM
PID constant read failure completion
flag from FeRAM
•CH Execution times monitor
•CH Execution pattern monitor
•CH Segment monitor
•CH Segment remaining time
•CH Zone PID monitor
•CH Wait status flag
•CH Hold status flag
•CH Advancing completion flag
•CH Pattern end output flag
•CH End status flag
•Cascade monitor
•CH Scaling value
•X0D: CH2 Alert flag
•Y01: Setting/operation mode command
•Y02: Error reset command
•Y04: CH1 Auto tuning start command
•Y05: CH2 Auto tuning start command
•Y08: FeRAM backup start command
•Y09: Default setting registration start
command
•Y0B: Setting change command
•Y0C: CH1 Forced PID control stop command
•Y0D: CH2 Forced PID control stop command
•CH Upper setting limiter
•CH Lower setting limiter
•CH Setting change rate limiter
•CH Upper output limiter
•CH Lower output limiter
•CH Output variation limiter
•CH Alert definition
Measured value (PV) is above upper
limit of measurable range (up scale)
Measured value (PV) is above lower
limit of measurable range (down scale)
Alert1
Alert2
Alert3
Alert4
Loop disconnection warning
MELSEC-Q
(From the previous page)
Reference
Section 5.5
Section 5.6
(To the next page)
5 - 2
5