Setting Ftp Parameters - Huawei SmartLogger1000 User Manual

SmartLogger1000
User Manual




7.26 Setting FTP Parameters

This topic describes how to set basic parameters of the FTP server and view the latest report
status over the WebUI.
The FTP function is used to access a third-party element management system (EMS). The
SmartLogger can report the configuration information and running data of the managed plant
system through the FTP. The third-party EMS can access Huawei devices with proper
configurations.
On the Settings tab page, choose Extended Parameters > FTP. On the displayed page, you
can set parameters in the Basic Parameters and Report Settings areas and view the
information in the Latest Report Status area, as shown in
limited permission, select the User name as Advanced User.
Issue 04 (2013-12-15)
When Connect Mode is set to Server, the NetEco connects to the SmartLogger as a client.
Generally, this mode applies to the scenario where the SmartLogger and NetEco are in the
same LAN.
When Connect Mode is set to Client, set an IP address and a port ID (16100 by default)
for the NetEco on the SmartLogger. This mode applies to remote access scenarios, for
example, when the SmartLogger and NetEco are not in the same LAN.
When Connect Mode is set to Server+Client, the SmartLogger connects to the NetEco as
a client or connects to a third-party EMS as a server. The SmartLogger can connect to a
third-party EMS and Huawei NetEco by Modbus and TCP. In this way, customers can
perform centralized monitoring by using a third-party EMS while using Huawei NetEco to
perform remote upgrade, log uploading, batch parameter setting, historical performance
data analysis, and historical alarm analysis.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Web User Interface
Figure 7-62. Because of the
142