Huawei SmartLogger1000 User Manual page 80

SmartLogger1000
User Manual
LCD
Here use the pages displayed when you
log in to the SmartLogger as Advanced
User.
Issue 04 (2013-12-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Operation Procedure
3. Enter the User name and Password by
pressing or , and then press
NOTE
 Because of the limited permission, select the
User name as Advanced User or Special User.
The initial password for Advanced User and
Special User is 000001. If you forget the
password, contact Huawei technical support for a
dynamic password that is effective only on that
current day. Change the password after login.
 After passing the permission validation, the
system keeps the authentication information for
30 seconds. If you exit from the Maintenance
page and log in again within 30 seconds, no
authentication is required.
4. Select USB Expansion and press
NOTE

Before this operation, connect the USB flash
drive to the USB port.
 If no USB flash drive is detected, the LCD
displays a message prompting No USB device
detected..
The system takes 5 to 10 seconds to detect the USB
flash drive. Then perform the following steps.
5. Choose Firmware Upgrade, and press
6. Press to select a specific device.
The SmartLogger and the inverters connected
to it can be upgraded.
The SUN2000 (1--7) on the left indicates that
this inverter connects to the Port 1 of the
SmartLogger and the communications address
for the RS485 port is 7.
6 User Interface
.
.
.
73