Connecting The Smartlogger To A Pc - Huawei SmartLogger1000 User Manual

SmartLogger1000
User Manual




----End
Follow-up Procedure
Take operations in reversed order to disconnect the SmartLogger from the EMI.

4.4 Connecting the SmartLogger to a PC

This topic describes how to connect the SmartLogger to a PC.
Procedure
Step 1 Connect one end of the network cable delivered together with the SmartLogger to its FE port.
Step 2 Connect the other end to the network port of the PC, as shown in
Issue 04 (2013-12-15)
Connect the RS485+ port of the EMI to the COM+ port of the SmartLogger and the
RS485- port of the EMI to the COM- port of the SmartLogger.
After connecting the cable, log in to the WebUI and set parameters under Environmental
Monitoring Instrument. For details about this operation, see
Parameters.
The EMI cannot be detected automatically. You need to add this device manually. For
details about this operation, see
When the SmartLogger is connected to an EMI and multiple inverters at the same time,
connect the EMI to the end of the daisy chain. For details, see
Inverters to the SmartLogger.
If the delivered network cable is shorter than the required length, note the following when preparing
network cable:
 Choose CAT 5E or above shielded network cables.
 It is suggested that the cable length is less than or equal to 100 meters.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6.2.14 Managing Devices.
4 Electrical Connections
7.24 Setting EMI
4.2.3 Connecting Multiple
Figure 4-10.
31