Setting Communications Parameters - Huawei SmartLogger1000 User Manual

SmartLogger1000
User Manual
LCD
----End

6.2.10 Setting Communications Parameters

This topic describes how to set the communications parameters for the SmartLogger on the
monitoring panel, including the parameters for the RS485 (baud rate, start address, and end
address), parameters for the Ethernet (IP address, subnet mask, gateway and DNS) and
parameters for the Server (Connect Mode, NMS IP, and Port Number).
Context



Procedure

Issue 04 (2013-12-15)
If you want to change the password for another account, exit from the Settings screen (without logging
in to the Maintenance screen), wait 30 seconds, log in by using the account for which you want to
change the password, and perform step 3 to step 7 in the preceding table.
Correctly set RS485 parameters to ensure normal communication between the
SmartLogger and the inverters and between the SmartLogger and the environmental
monitoring instrument.
Correctly set Ethernet parameters to ensure proper operation of Ethernet ports and
functions of logging in to the embedded WebUI, connecting to the element management
system, and sending emails.
Correctly set NetEco parameters to ensure normal communication between the
SmartLogger and the NetEco.
The following table describes the procedure for setting communications parameters. The
parameter values in the following figures are for reference only.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Operation Procedure
6. Enter a new password and press
Increase or decrease the value by pressing
or . Switch between data bits by pressing
.
7. Enter the new password again and press
.
NOTE
Ensure that you enter the new password twice
coherently. Otherwise, an error message is
displayed.
After the password is changed successfully,
the LCD displays operation success
information.
6 User Interface
.
64