Application Indicator Function - Panasonic SF4D Series Instruction Manual

3-10 Application indicator function (12-core cable)
This function allows the upper application indicator and lower application indicator to be used as
an application indicator.
Use a 12-core cable, and set DIP switch 3 to ON.
You can select application indicator lights / turns OFF with the application indicator input 1 wire
(gray) or application indicator input 2 wire (gray / black).
DIP switches of receiver
ON OFF
<Reference>
The operation (lights, blink, turns OFF) settings of the application indicator can be changed using
the communication module SF4D-TM1 (option) and Configurator Light Curtain software.
Wiring diagram
<Using PNP output>
(Brown)
(Gray)
(Gray / Black)
(Red)
(Pale blue)
(Blue)
(Orange)
(Orange / Black)
(Orange /
Black)
(Orange)
(Brown)
(Black)
(White)
(Pale blue)
(Blue)
*Switch S1
● Application indicator input 1 / 2
Vs to Vs − 2.5V (sink current 5mA or less):
Note: Vs is the supply voltage.
© Panasonic Industrial Devices SUNX Co., Ltd. 2017
Application indicator
Lights green
Lights red
3
Lights orange
Turns OFF
Short circuit: When using PNP output: Connect to +V
*S1
+
−
K1
K2
Short circuit (Note)
Application indicator
input 1 (Gray)
Short circuit
Open
Short circuit
Open
When using NPN output: Connect to 0V
<Using NPN output>
(Brown)
(Red)
(Pale blue)
(Gray)
(Gray / Black)
(Blue)
(Orange)
(Orange / Black)
(Orange /
Black)
(Orange)
(Brown)
(Black)
(White)
(Pale blue)
(Blue)
*Switch S2
● Application indicator input 1 / 2
0 to +2.5V (source current 5mA or less):
Functions
Application indicator
input 2 (Gray / Black)
Open
Short circuit
Short circuit
Open
+
−
*S2
K1
K2
Short circuit
115