Mitsubishi Electric MELSEC Q Series User Manual page 232

11 TROUBLESHOOTING
Warning
code
The target position change request was
executed in the following cases.
• In operation stop
• In deceleration by stop command,
sudden stop command or error
11014
• In JOG operation
• In OPR
• In linear interpolation
• In current value change
• In pausing
Operation warnings (11000 to 11999) (continued)
Error
At target position change
request
Operation status at
Error check
warning occurrence
The target position
change is not
executed.
11 - 15
MELSEC-Q
Remedy
Change the target position when
the speed change can be
executed.