Sharp PN-L803C Service Manual page 23

CHAPTER 2 INSTALLATION, ADJUSTMENT, SETTING
1. INSTALLATION
1 – 1.INSTALLAING PRECAUTIONS
- This product is for use indoors.
- A mounting bracket compliant with VESA specifications is
required.
- Since the monitor is heavy, consult your dealer before installing,
removing or moving the monitor.
- Mounting the monitor on the wall requires special expertise and
the work must be performed by an authorized SHARP dealer.
You should never attempt to perform any of this
yourself. Our company will bear no responsibility
accidents or injuries caused by improper mounting or
mishandling.
- Use the monitor with the surface perpendicular to a level
surface. If necessary, the monitor may be tilted up to 20
degrees upward.
- When moving the monitor, be sure to hold it with the
and the unit bottom. Do not grasp the screen or
may cause product damage, failure, or injury.
- This monitor should be used at an ambient temperature
between 41°F (5°C) and 95°F (35°C). Provide enough
space around the monitor to prevent heat from
accumulating inside.
- Be careful of high temperatures in the surrounding area. When
installing the monitor inside a housing, or if the ambient
temperature may be outside of the range of 41°F (5°C) to 95°F
(35°C), install a fan or take other measures to keep the ambient
temperature within the required range.
- Temperature condition may change when using the monitor
together with the optional equipments recommended by
SHARP. In such cases, please check the temperature
condition specified by the optional equipments.
- Do not block any ventilation openings. If the temperature
inside the monitor rises, this could lead to a malfunction.
- Do not place the monitor on a device which generates heat.
- Adhere to the following when installing the monitor in its portrait
orientation. Failing to adhere to the following may cause
malfunctions.
- Install the monitor such that the power LED is located on the
bottom side.
- Set the MONITOR on the MONITOR menu to PORTRAIT.
PN-L803C/80TC3 INSTALLATION, ADJUSTMENT, SETTING, OPERATION 2 - 1
- Be sure to clamp the power cord (supplied) onto the
cable clamp attachment using the supplied cable clamp.
When clamping the power cord, take care not to stress
the terminal of the power cord. Do not bend the power
cord excessively.
work
for
handles
Use the supplied vertical sticker when you install the
-
tray. This
monitor in portrait orientation.