Sharp PN-L803C Service Manual page 76

■ Error message
- Could not save. Drive has no free memory.
There is only no availability which saves the user settings at
USB flash drive
- USB not recognized. Check the connection.
USB flash drive cannot be recognized (mount failure)
- Failed to save file.
The format of USB flash drive is outside correspondence
The file name which it tries to write in overlaps
Writing is not made by write-protection etc.
Abnormalities occur at the time of other writing
PN-L803C/80TC3 SERVICE MENU/VARIOUS SETTING TOOL OPERATING PROCEDURES 4- 10
6 – 7. USER SETTING VALUE PRESERVATION
TO USB FLASH DRIVE
■
USB flash drive
Use the USB flash drive corresponding to the following
standard.
- Format : FAT32/FAT16 (Upper limit of the cluster size : 32KB)
- USB : 2.0/1.1
<CAUTION>
・It does not correspond to SD card reader.
・It does not correspond to USB HUB
・Don't use the USB flash drive enciphered
・Set the proper volume label name.
・When the model name is changed right before this procedure,
turn OFF and ON the main power.
■
User setting value backup
1) Press [ENTER] key in "SAVE/RESTORE SETTINGS
VALUE" of SERVICE MENU3. The following screen is
displayed
2) If a cursor is united with [SAVE] and press [ENTER] key,
Select the item to save and press [ENTER] key.
ALL Almost all preset values are saved except a setup
changed by the state of a main part.
Information which is not saved
- IP address of LAN
- The preset value etc. which change with input
signals, such as a clock and a phase
PICTURE Only setup of image adjustment is saved.
ONLY
3) Connect USB flash drive to the monitor
4) If a cursor is united with [Yes] and press [ENTER] key,
preservation will begin.
5) If preservation is successful, it will return to SERVICE MENU.
The file of [XXlog_(model name)_(serial number)_(time).dat] is
created by the root directory of a USB flash drive [Model name]
folder.