Sharp PN-L803C Service Manual page 85

11-4. USER SETTING VALUE RESTORING
PROCEDURES
1) Press [Connection Setting] button to make connection setting.
2) Turn ON the information display.
3) Press [Write ...] button, and select the saved backup file.
4) After completion of restoring, the information display is reset.
<CAUTION>
-
When the massage of "This Monitor is not Support. Is restore
processing continued?", "Backup data is not for this monitor. Is
restore processing continued?", "Serial Number is different
between monitor and backup data. Is restore processing
continued?", or "Model Name is different between monitor and
backup data. Is restore processing continued?" is displayed, the
backup of the target set may be failed. Check again, and
perform restoring.
-
Some setting contents cannot be saved by this tool.
WHEN "TIME OUT. CANNOT CONNECT. PLEASE
CONFIRM SETTING." IS DISPLAYED:
-
Check the power status of the information displayed which is
connected.
-
Check to confirm that the PC and the information display are
properly connected with an RS-232C cable.
WHEN "CANNOT OPEN INTERFACE. CANNOT
CONNECT. PLEASE CONFIRM SETTING" IS
DISPLAYED:
-
Check to confirm that the port which is set by another tool
is not used. If the port is used by another tool, turn OFF
the tool.
WHEN "THIS MONITOR IS NOT SUPPORT. IS XXXX
PROCESSING CONTINUED?" IS DISPLAYED:
-
The display which is connected is not supported by this tool. Use
a tool which supports the displayed connected.
PN-L803C/80TC3 SERVICE MENU/VARIOUS SETTING TOOL OPERATING PROCEDURES 4- 19