Figure 3
1. Roller support
2. Upper holes—27-inch
cutting units
2.
If needed, remove the capscrew, locknut, and
roller.
3.
Align the roller to the other roller support holes.
4.
Secure the roller to the roller support with the
capscrew and locknut.
5.
Repeat steps
2
through
the machine.
g019541
3. Lower holes—32-inch
cutting units
4
at the other side of
2
Installing the Cutting Units
Parts needed for this procedure:
1
Front hose guide (right)
1
Front hose guide (left)
Preparing the Machine
1.
Remove the reel motors from the shipping
brackets.
2.
Remove and discard the shipping brackets.
Preparing the Cutting Units
1.
Remove the cutting units from the cartons.
2.
Assemble and adjust as described in the cutting
unit Operator's Manual.
3.
Make sure that the counterweight
installed at the proper end of the cutting unit as
described in the cutting unit Operator's Manual.
1. Counterweight
12
(Figure
Figure 4
4) is
g003320