Lubrication; Greasing The Bearings And Bushings - Toro Reelmaster 7000-D Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours Grease the bearings
and bushings immediately after
washing the machine.
Grease Specification: No. 2 lithium grease
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. The grease fitting locations and quantities are
as follows:
•
Brake shaft pivot bearings (5), refer to
112
Figure 112
•
Rear axle-pivot bushing and steering
cylinder, refer to
Figure 113
59).
Figure
Figure 113
•
Steering cylinder ball joints (2), refer to
Figure 114
1. Top fitting on king pin
•
Tie rod ball joints (2), refer to
g009704
•
King pin bushings (2), refer to
Note:
only be lubricated annually (2 pumps).
•
Lift arm bushings (1 per cutting unit), refer
to Figure 115
g380870
•
Lift cylinder bushings (2 per cutting unit),
refer to
62
Figure 114
Figure 114
The top fitting on the king pin should
Figure 115
Figure 115
g009706
Figure 114.
g015159