Toro Reelmaster 7000-D Operator's Manual page 24

Parking-Brake Pedal
To engage the parking brake,
pedals together with the pedal-locking latch, push
down on the right brake pedal while engaging the toe
pedal.
Note:
When the parking brake is engaged, the
parking brake symbol displays in the InfoCenter.
To release the parking brake, press 1 of the brake
pedals until the parking-brake latch retracts.
Traction Pedal
The traction pedal (Figure
and reverse operation. Press the top of the pedal to
move forward and the bottom of the pedal to move
backward. Ground speed depends on how far you
press the pedal. For no load, maximum ground speed,
press the engine-speed switch to high idle and then
fully press the traction pedal.
To stop, reduce your foot pressure on the traction
pedal and allow it to return to the center position.
Tilt Steering Pedal
To tilt the steering wheel toward you, press the foot
pedal (Figure 42) down, and pull the steering tower
toward you to the most comfortable position and then
release the pedal.
Speed-Limiter Screws
Adjust the screw(s) (Figure
the traction pedal can be pressed in the forward or
reverse direction to limit speed.
Important:
The speed-limiter screw must stop the
traction pedal before the pump reaches full stroke
; otherwise, damage to the pump may occur.
Figure 43
1. Reverse speed limiter
screw
2. Forward speed limiter
screw
(Figure 42) connect the
42) controls the forward
43) to limit the amount
3. Spacers
4. Mow-speed limiter
Mow-Speed Limiter
When the mow-speed limiter
forward, it allows the cutting units to engage and limits
the maximum ground speed during mowing. You
change the position of the spacers to adjust mowing
ground speed. When driving machine between job
sites, rotate the mow-speed limiter back for maximum
transport speed.
Lower Mow/Raise Control Lever
Use the lower mow/raise control lever
raises and lowers the cutting units. The lever also
starts and stops the reels when the reels are enabled
in the mow mode.
Note:
The cutting units cannot be lowered when the
mow/transport lever is in the transport position.
1. Lower mow/raise control
lever
2. Key switch
3. InfoCenter
Key Switch
The key switch
O /P , and S
N REHEAT
InfoCenter
The InfoCenter LCD display shows information about
your machine, such as the operating status, various
diagnostics, and other information about the machine
(Figure 44).
g015075
PTO Switch
The PTO switch
and D
ISENGAGE
engage the cutting-unit blades. Press the button back
to disengage the cutting-unit blades.
24
(Figure 43) is rotated
Figure 44
4. PTO switch
5. Engine-speed switch
6. Headlight switch
(Figure 44) has 3 positions: O
.
TART
(Figure 44) has 2 positions: E
. Press the PTO button forward to
(Figure 44)
g021208
,
FF
NGAGE