Replacing The Hydraulic Filters - Toro Reelmaster 7000-D Operator's Manual

Figure 162
1. Hydraulic-tank cap
2. Dipstick
3. Remove the hydraulic-tank cap from the tank.
4. Remove the dipstick from the filler neck and
wipe it with a clean rag.
5. Insert the dipstick into the filler neck; then
remove it and check the fluid level.
The correct hydraulic-fluid level is between the
Full mark and the Add mark on the dipstick.
6. If the level is low, add the specified hydraulic
fluid to raise the fluid level to the Full mark.
7. Install the dipstick and hydraulic-tank cap to the
tank.
Replacing the Hydraulic
Filters
Service Interval: Every 1,000 hours—If you
are using the recommended
hydraulic fluid, replace the
hydraulic filters.
Every 800 hours—If you are not using the
recommended hydraulic fluid or have ever
filled the reservoir with an alternative fluid,
replace the hydraulic filters.
Use the following Toro hydraulic filters:
Name Toro Part No.
Return filter 94-2621
g370529
3. Full mark
4. Add mark
Location
Below the right
frame channel.
Use the following Toro hydraulic filters:
(cont'd.)
75-1310
Charge filter
Important:
Using another type of filter may void the
warranty on some components.
Replacing the Charge Filter
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Tilt the seat; refer to
3. Clean the area around the charge filter and filter
head (Figure
1. Charge-filter head
4. Align a drain pan under the filter, and remove
the filter.
5. Wipe the filter mounting filter surface of the filter
head with a clean rag.
6. Lubricate the new filter gasket and fill the
filter with the specified hydraulic fluid; refer to
Hydraulic Fluid Specifications (page
7. Thread the filter onto the filter head until the
gasket contacts the mounting plate, then tighten
the filter an additional 1/2 turn.
86
Under the seat
plate.
59).
Tilting the Seat (page
163).
Figure 163
2. Charge filter
60).
g370535
85).