Positioning the Turf Compensating
Spring and Installing the Hose
Guide
Cutting Units 4
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
1.
If the hairpin is installed in the rear hole of the
compensation-spring rod—remove the hairpin
and insert it in the hole next to the bracket
(Figure
6).
1. Hairpin
2.
Remove the 2 flange locknuts (3/8 inch) and 2
carriage bolts (3/8 x 1-1/4 inches) that secure
the turf-compensator bracket to the cutting-unit
frame
(Figure
7).
Figure 5
5. Cutting unit 5
6. Reel motor
7. Weight
Figure 6
1. Carriage bolt (3/8 x 1-1/4
g375671
inches)
2. Turf-compensator bracket
3.
Remove the flange locknut (3/8 inch) that
secures the capscrew of the turf compensation
spring to the right tab of the carrier frame,
and remove the compensation spring from the
cutting unit
Note:
Do not remove the flange serrated nut
from the capscrew.
1. Capscrew
2. Right tab (Carrier frame)
4.
Assemble the capscrew of the turf compensation
spring to the right tab of the carrier frame
9) with the flange locknut (3/8 inch).
g375689
13
Figure 7
3. Flange locknut (3/8 inch)
(Figure
8).
Figure 8
3. Flange locknut (3/8 inch)
g375690
g375691
(Figure