Toro Reelmaster 7000-D Operator's Manual page 25

Engine-Speed Switch
The engine-speed switch
change the engine speed. By momentarily tapping
the switch, you can increase or decrease the engine
speed in 100 rpm increments. Press and hold the
switch to move the engine speed directly to high or low
idle, depending on which end of the switch you press.
Headlight Switch
Press the switch to turn on the headlights
Power Point
Use the power point (Figure
12-volt electrical accessories.
Figure 45
1. Power point
Bag Holder
Use the bag holder (Figure
Backlap Levers
Use the backlap levers to control the cutting unit
rotation direction when backlapping the reels
46).
(Figure 44) has 2 modes to
(Figure
45) to power optional
2. Bag holder
45) for storage.
(Figure
44).
1. Front cutting-unit backlap
lever
Using the InfoCenter LCD Display
The InfoCenter LCD display shows information about
your machine, such as the operating status, various
diagnostics, and other information about the machine
(Figure 47) There is a splash screen and main
information screen of the InfoCenter. You can switch
between the splash screen and main information
screen, at any time, by pressing any of the InfoCenter
buttons and then selecting the appropriate directional
g368823
arrow.
1. Indicator light
2. Right button
•
Left Button, Menu Access/Back Button—press this
button to access the InfoCenter menus. You can
use it to back out of any menu you are currently
using.
•
Middle Button—use this button to scroll down
menus.
•
Right Button—use this button to open a menu
where a right arrow indicates additional content.
25
Figure 46
2. Rear cutting-unit backlap
lever
Figure 47
3. Middle button
4. Left button
g370565
g020650