Toro Reelmaster 7000-D Operator's Manual page 27

InfoCenter Icon Description (cont'd.)
Symbols are often
combined to form
sentences. Some
examples are shown
below
Operator should put machine in
neutral
Engine start denied
Engine shutdown
Engine coolant too hot
Hydraulic fluid too hot
NOx control diagnosis malfunction;
drive the machine back to the shop
and contact your authorized Toro
distributor (software version F and
later).
DPF ash accumulation notification.
Refer to
(page 42)
for details.
Sit down or set parking brake
Accessible only by entering PIN
Using the Menus
To access the InfoCenter menu system, press the
menu access button while at the main screen. This
will bring you to the main menu. Refer to the following
tables for a synopsis of the options available from
the menus:
Main Menu
Menu Item
Faults
Service
DPF Ash Accumulation
in the maintenance section
Description
The Faults menu contains
a list of the recent machine
faults. Refer to the Service
Manual or your authorized
Toro distributor for more
information on the Faults
menu and the information
contained there.
The Service menu contains
information on the machine
such as hours of use counters
and other similar numbers.
Diagnostics
Settings
About
Service
Menu Item
Hours
Counts
Diagnostics
Menu Item
Cutting Units
Hi/Low Range
PTO
Engine Run
Backlap
Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast
Front Backlap Reel Speed
27
The Diagnostics menu
displays the state of each
machine switch, sensor, and
control output. You can use
this to troubleshoot certain
issues as it will quickly tell you
which machine controls are on
and which are off.
The Settings menu allows
you to customize and modify
configuration variables on the
InfoCenter display.
The About menu lists the
model number, serial number,
and software version of your
machine.
Description
Lists the total number of hours
that the machine, engine, and
PTO have been on, as well
as the number of hours the
machine has been transported
and service due
Lists numerous counts the
machine has experienced
Description
Indicates the inputs, qualifiers,
and outputs for raising and
lowering the cutting units
Indicates the inputs, qualifiers,
and outputs for driving in
transport mode
Indicates the inputs, qualifiers,
and outputs for enabling the
PTO circuit
Indicates the inputs, qualifiers,
and outputs for starting the
engine
Indicates the inputs, qualifiers,
and outputs for operating the
backlap function
Description
Controls the units used on the
InfoCenter (English or Metric)
Controls the language used
on the InfoCenter*
Controls the brightness of the
LCD display
Controls the contrast of the
LCD display
Controls the speed of the front
reels in backlap mode