Toro Reelmaster 7000-D Operator's Manual page 29

4. Press the middle button to enter the PIN code
(Figure 49D).
Wait until the red indicator light of the InfoCenter
illuminates.
Note:
If the InfoCenter accepts the PIN code
and the protected menu is unlocked, the word
"PIN" displays in the upper right corner of the
screen.
Note:
Rotate the key switch to the O
then to the O position locks the protected menu.
N
You can view and change the settings in the Protected
Menu. Once you access the Protected Menu, scroll
down to Protect Settings option. Use the right button
to change the setting. Setting the Protect Settings to
O allows you to view and change the settings in
FF
the Protected Menu without entering the PIN code.
Setting the Protect Settings to O
options and requires you to enter the PIN code to
change the setting in the Protected Menu. After you
set the PIN code, rotate the key switch O
to the O position to enable and save this feature.
N
Setting the Auto Idle
1. In the Settings Menu, scroll down to Auto Idle.
2. Press the right button to change the auto idle
time between Off, 8S, 10S, 15S, 20S, and 30S.
Setting the Blade Count
1. In the Settings Menu, scroll down to Blade Count
2. Press the right button to change the blade count
between 5, 8, or 11 blades.
Setting the Mow Speed
1. In the Settings Menu, scroll down to Mow Speed.
2. Press the right button to select mow speed.
3. Use the center and right button to select the
appropriate mow speed set on the mechanical
mow-speed limiter on the traction pedal.
4. Press the left button to exit mow speed and save
the setting.
Setting the Height of Cut (HOC)
1. In the Settings Menu, scroll down to HOC.
2. Press the right button to select HOC.
3. Use the center and right button to select the
appropriate HOC setting.
Note:
If the exact setting is not displayed, select
the nearest HOC setting from the list displayed.
4. Press the left button to exit HOC and save the
setting.
position and
FF
hides the protected
N
and back
FF
29
Setting the Front and Rear Reel
Speeds
Although the front and rear reel speeds are calculated
by inputting the number of blades, mow speed and
HOC into the InfoCenter, you can manually change the
setting to accommodate different mowing conditions.
1. Scroll down to the F Reel RPM, R Reel RPM,
or both.
2. Press the right button to change the reel speed
value. As the speed setting changes, the display
continues to show the calculated reel speed
based on blade count, mow speed, and HOC
previously entered, but the new speed value
also displays.