Installing the Kickstand
For each cutting unit, secure the kickstand to the
chain bracket with the snapper pin
Figure 21
1. Chain bracket
2. Snapper pin
(Figure
21).
g004144
3. Cutting-unit kickstand
Increasing the Rear Cutting Unit
Pivot Angle
Increase the pivot angle of the rear cutting units by
removing the 2 spacers, 2 hex-socket screws, and 2
flange locknuts
(Figure 22
carrier frames of cutting units 2 and 3.
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
1. Hex-socket screw
2. Spacer
17
and
Figure
23) from the
Figure 22
5. Cutting unit 5
6. Reel motor
7. Weight
Figure 23
3. Carrier frame
4. Flange locknut
g367812
g033150