Toro Reelmaster 7000-D Operator's Manual page 28

Rear Backlap Reel Speed
Protected Menus
Auto Idle
Blade Count
Mow Speed
Height of cut (HOC)
F Reel RPM
R Reel RPM
*Only "operator-faced" text is translated. Faults,
Service, and Diagnostics screens are "service-faced.".
Titles will be in the selected language, but menu items
are in English.
Protected under Protected Menus—accessible only
by entering PIN
About
Menu Item
Model
SN
Machine Controller Revision
InfoCenter Revision
CAN Bus
Protected Menus
There are 7 operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter:
Auto Idle, Time Delay, Blade Count, Mow Speed,
Height of Cut (HOC), F Reel RPM, and R Reel RPM.
These settings can be locked by using the Protected
Menu.
Note:
At the time of delivery, the initial password
code is programmed by your distributor.
Controls the speed of the rear
reels in backlap mode
Allows a person authorized
by your company with the
PIN code to access protected
menus
Controls the amount of time
allowed before returning the
engine to low idle when the
machine is stationary
Controls the number of blades
on the reel for reel speed
Controls the ground speed for
determining the reel speed
Controls the height of cut
(HOC) for determining the reel
speed
Displays the calculated reel
speed position for the front
reels. The reels can also be
manually adjusted
Displays the calculated reel
speed position for the rear
reels. The reels can also be
manually adjusted
Description
Lists the model number of the
machine
Lists the serial number of the
machine
Lists the software revision of
the master controller
Lists the software revision of
the InfoCenter
Lists the machine
communication bus status
Accessing Protected Menus
Note:
The factory default PIN code for you machine
is either 0000 or 1234.
If you changed the PIN code and forgot the code,
contact your authorized Toro distributor for assistance.
1. From the M
AIN
scroll down to the S
right button (Figure
2. In the S
ETTINGS
scroll down to the P
the right button
3. To enter the PIN code, press the center button
until the correct first digit appears, then press
the right button to move on to the next digit
(Figure 49B and
until the last digit is entered and press the right
button once more.
28
M , use the center button to
ENU
M and press the
ETTINGS ENU
48).
Figure 48
M , use the center button to
ENU
M and press
ROTECTED ENU
(Figure 49A).
Figure 49
Figure 49C). Repeat this step
g028523
g028522