Toro Reelmaster 7000-D Operator's Manual page 49

Important:
Perform a recovery regeneration
to restore the PTO function; refer to
to Perform a Parked or Recovery Regeneration
(page 49) and Performing a Parked or Recovery
Regeneration (page 49).
Note:
The Home screen displays the PTO disabled
Icon; refer to Figure 84
Messages (page 48).
DPF Status-Limitation
•
If the engine computer requests a recovery
regeneration or is processing a recovery
regeneration and you scroll down to the P
R option, parked regeneration locks and the
EGEN
lock icon (Figure 87) appears in the lower right
corner of the InfoCenter.
•
If the engine computer has not requested a
recovery regeneration and you scroll down
to the R R
ECOVERY
regeneration locks and the lock icon
appears in the lower right corner of the InfoCenter.
Preparing to Perform a Parked or Recovery
Regeneration
1. Ensure that the machine has fuel in the tank for
the type of regeneration you are performing:
•
Parked Regeneration: Ensure that you
have 1/4 tank of fuel before performing the
parked regeneration.
•
Recovery Regeneration: Ensure that you
have 1/2 tank of fuel before performing the
recovery regeneration.
Preparing
in Parked Regeneration
Figure 87
option, the recovery
EGEN
(Figure
Figure 88
2. Move the machine outside to an area away from
combustible materials.
3. Park the machine on a level surface.
4. Ensure that the traction control or motion-control
levers are in the N
5. If applicable, shut off the PTO, and lower the
cutting units or accessories.
6. Engage the parking brake.
7. Set the throttle to the low I
Performing a Parked or Recovery
ARKED
Regeneration
CAUTION
The exhaust temperature is hot (approximately
600°C (1,112°F) during DPF regeneration. Hot
exhaust gas can harm you or other people.
• Never operate the engine in an enclosed
area.
• Make sure that there are no flammable
materials around the exhaust system.
g224625
• Never touch a hot exhaust system
component.
• Never stand near or around the exhaust
pipe of the machine.
88)
Important:
DPF regeneration if you increase the engine speed
from low idle or release the parking brake.
1. Access the DPF Regeneration menu, press
the center button to scroll down to either the
P
ARKED
R
EGEN
right button to select the start the regeneration
(Figure
g224628
49
position.
EUTRAL
DLE
The computer of the machine cancels
R S option or the R
EGEN TART
S option (Figure 89), and press the
TART
89).
position.
ECOVERY