Yamaha SIGMA-G5SII Service Information page 191

 Eco-Function Setting
⇒Press the +/- button to set it to the following value and determine the value using the
mode change button.
When the above settings are completed, hold down the mode change button for 3
seconds or more to escape from the setting mode.
(3) When the above settings are completed, press the sensitivity setting button without the
object to be detected. Now, all the settings have been completed.
(4) Finally, set up the feeder (8mm or 32mm) and disengage the feeder hook. Then, check
that the value is " 1000 " or less. Check it in the three locations (right end, center and left
lanes) and if there is no problem, the adjustment is completed.
Service Information
SI1705004E-00=SIGMA-G5SII Service Manual
191/273
For Service Engineer