Unit Adjustment; Noz.chng" Window (In Debug Mode) - Yamaha SIGMA-G5SII Service Information

2.6. Unit Adjustment

This section is used for each maintenance operation.
Note:
The "Cutter" item is displayed only in the "Debug" mode.
For safety reasons, only the person who completed the training course should use this mode.
Refer to the "Debug Mode" separately, for the Debug mode display procedure.

2.6.1. "NOZ.CHNG" Window (in Debug Mode)

In this operation window, individual nozzle is attached or removed.
Note:
The items in the red frame, are displayed only in the Debug mode.
Only the trained person can operate the items in the red frame, because such operation might damage
the nozzle.
Service Information
SI1705004E-00=SIGMA-G5SII Service Manual
71/273
For Service Engineer