Yamaha SIGMA-G5SII Service Information page 52

(6) After the pattern program change, the window is transferred. For the placement
preparation, select the setup window.
(7) Change the conveyor width to 71.0 mm (The default clearance value is acceptable).
It is changed in the [Automatic Operation Specified Target Position Move] window.
(Operation Sequence: Select [Setup], [Conveyor Setup], [Automatic Operation
Specified Target Position Move] in this order)
Service Information
Fig. A44
Fig. A45
SI1705004E-00=SIGMA-G5SII Service Manual
52/273
For Service Engineer