NEC SL2100 Hardware Manual page 128

ISSUE 4.0
Wall Mount the Terminal
This section shows the installation procedure for wall mounting the terminal.
1. Turn the terminal over (key side down).
2. Remove the hanger hook from the terminal, and then reverse it and reinsert it to the terminal.
3. Turn the terminal over, and then spread the tilt legs.
4. Install the Wall Mount Unit on the wall or on the wall plate using one of the following procedures.
Mount Terminal on Wall using Wall Mount Unit
Attach the Wall Mount Unit to the wall using six screws or using two wall mounted screws.
Mount Terminal on Wall Plate using Wall Mount Unit
Locate the screw holes on the base and hang the cover over the screws on the wall plate.
5. Connect the LAN Cable. Refer to Connecting the IP Multiline Telephone in this section.
6. Align the four cutouts on the bottom of the terminal with the tabs on the Wall Mount Unit.
7. Plug one end of the line cord into the wall receptacle.
INSTALLING THE MULTILINE TELEPHONES AND OPTIONAL TERMINALS
SL2100
126